But i m no expert.
Check mems sensor samsung washer.
Snapped the wire clamp from the bracket at the top of the washer then unplugged the sensor.
It can be tested through the dc92 01624a board.
If the water during the wash is too cold or hot then you might need to check the temperature sensor in the washing machine and maybe even replace it with a new one as you might have samsung washer temperature sensor problem.
Samsung washer wf520abp xaa my repair advice.
Vrt is connected to the pcb of the display.
Removed the lid by taking out two screws in the back and sliding it off.
I flipped the washer and took the current one off and put it back on should be simple enough to swap out.
Switch off the appliance at the mains then wait 1 minute.
My washing machine is showing a ue code during a spin cycle.
Fluctuation in the supply voltage.
Check to make sure the washing machine is not connected to any other apparatus or to an extension cable.
Temperature is controlled by special integrated sensors.
One of its main features is the rapid heating of water.
Installed the new sensor following the steps in reverse.
Internal failure of the mems sensor in the samsung washer the 8c error code is displayed when the accelerometer is silent or gives incorrect weak signals to the control module.
Sometimes the washer runs its cycle fine sometimes it starts yelling in the middle and fills and drains over and over.
Then check the motor winding coil unplug the connector and read resistances at any two of the three terminals on motor should be 19 3o.
15 minute repair with a 50 part.
Below are dimensions for the samsung top load washers wa52j8060a wa8700 wa52j8700a with activewash.
Removed the two screws holding the sensor to the top of the drum.
Then check the dc31 00098a dc31 00098a rotor position sensor and wiring.
Check the power cord is plugged in properly.
To have the repair person even come to the house would have been 80 plus parts and labor evidentially a second visit.
Samsung top load washer self clean mode.
From what i ve researched it looks to be the mems sensor.
